Tuscaloosa Window Pros provides professional entry doors and masonry openings in Tuscaloosa, AL for residential and commercial properties across Tuscaloosa County and the Black Warrior valley. An entry door in a brick-veneer wall is constrained by the masonry opening around it, and that single fact decides whether you are buying a door or a small construction project. It is worth establishing before anyone shows you a brochure.
The older stock in this county is full of openings that are not a standard size. Houses built before the industry settled on common dimensions have doors measuring thirty-five and a half inches, or heads at six feet nine and three-quarters, and the brick was laid to whatever frame was standing there. You cannot simply order a door and expect it to drop in.
There are three honest routes and the price differs by a lot. Hang a new slab in the frame you already have, which works where jamb and threshold are sound and the hinge positions can be matched. Replace the frame and door as a prehung unit sized to the existing masonry opening, which usually means a custom order and a wider brick mould to cover the gap. Or alter the opening, which means veneer and lintel work.
We check the jamb and threshold with an awl before recommending any of them. In this climate the rot is almost always at the bottom of the strike-side jamb and under the threshold, where water sat behind a caulk joint for years. A frame that is sound above and gone at the base can sometimes be repaired with a jamb splice and a new sill for far less than a replacement.
Material we choose for the exposure. A fibreglass slab with a fibreglass edge is the safest choice on an unprotected south or west entry here, because it will not swell, will not rot and holds a stain or a paint colour without seasonal movement. Steel is fine under a real porch and cheaper. Solid wood is a maintenance commitment we will happily quote and want you to enter with your eyes open.
Sidelights and transoms are where the money goes, and where the leaks come from. Every mull joint in a door assembly is a seam that has to be sealed, and in a masonry opening those joints sit tight against the brick return. If the existing unit has sidelights and they are not needed, deleting them simplifies the assembly and improves the seal.
Houses built or rebuilt since the early 2010s are much simpler. Standard openings, standard sizes, a prehung unit in a clad wall, and a straightforward swap with the pan set and the flashing re-lapped properly behind the siding. Those are day jobs rather than projects, and they should be priced like it.
Storm doors are worth a word. On a south or west entry with no porch, a full-glass storm door will cook the slab behind it and can void the door warranty, and we would rather fit a partial-vent unit or none at all than replace a warped door in three years. We measure the masonry opening and the frame separately, list all three routes with prices, and say which one we would choose here.
Our licensed and insured team brings the right materials and equipment to every job — brick veneer built up around the original window frame, brick mould casing bedded into the mortar joint at the head, steel lintel angles carrying the veneer over each masonry opening, integral nailing flanges lapped over the weather-resistive barrier, pocket inserts anchored into the surviving jamb rather than the framing, sloped sill pans with end dams under full-frame units — and backs the work with a written workmanship warranty. We serve Tuscaloosa and nearby communities including Northport, Holt, Cottondale, Brookwood.
What We Handle
Everything our entry doors and masonry openings in Tuscaloosa covers
One crew, one point of contact, and the full range of entry doors and masonry openings work in Tuscaloosa, AL. If it is on this list we do it in house rather than handing it to a subcontractor:
- entry doors Tuscaloosa
- front door replacement Alabama
- fiberglass entry door
- steel entry door
- entry door sidelights and transom
- door slab vs full frame replacement
- entry door threshold replacement
- non standard door opening brick
- entry door weatherstripping
- entry door multipoint lock
- wood entry door humid climate
- entry door glass insert
- storm door installation
- entry door cost Tuscaloosa
- door jamb rot repair
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Tuscaloosa services.
Materials, equipment and how we do entry doors and masonry openings
The difference between entry doors and masonry openings that lasts and entry doors and masonry openings that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with brick veneer built up around the original window frame, brick mould casing bedded into the mortar joint at the head, steel lintel angles carrying the veneer over each masonry opening, integral nailing flanges lapped over the weather-resistive barrier, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Tuscaloosa job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of window work in Tuscaloosa County and the Black Warrior valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do entry doors and masonry openings outside Tuscaloosa
Tuscaloosa Window Pros covers Tuscaloosa and the surrounding communities of Tuscaloosa County and the Black Warrior valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Entry Doors and Masonry Openings in Northport, AL — Tuscaloosa County, population 31,125
- Entry Doors and Masonry Openings in Holt, AL — Tuscaloosa County, population 3,413
- Entry Doors and Masonry Openings in Cottondale, AL — Tuscaloosa County, population 3,130
- Entry Doors and Masonry Openings in Brookwood, AL — Tuscaloosa County, population 2,504
- Entry Doors and Masonry Openings in Coaling, AL — Tuscaloosa County, population 2,035
- Entry Doors and Masonry Openings in Coker, AL — Tuscaloosa County, population 904
Start on the Tuscaloosa Window Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Tuscaloosa Chooses Tuscaloosa Window Pros
- ✓We read the outside of the wall before the inside of the window, because a brick-veneer opening and a flanged clad-wall opening are two different jobs at two different prices
- ✓Every proposal states whether the unit is a pocket insert or a full-frame replacement, and how much glass width you give up to get the cheaper one
- ✓We will not cut a brick veneer to sell you a bigger opening when the existing masonry opening can carry the window you actually need
- ✓On clad walls we re-lap self-adhered flashing over the nailing fin in sequence, rather than running a bead of sealant around the perimeter and calling it flashed
The standards behind entry doors and masonry openings
Quality here is not a matter of opinion — it is written down. The entry doors and masonry openings work we do in Tuscaloosa follows published industry standards: NFRC sets the U-factor and SHGC ratings on every window label, and ENERGY STAR defines the efficiency thresholds by climate zone. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every entry doors and masonry openings project in Tuscaloosa gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free entry doors and masonry openings free estimate in Tuscaloosa, or request a quote and we'll get right back to you.