Tuscaloosa Window Pros: Window Replacement, Glass and Doors
Expert residential and commercial window services across Tuscaloosa County. Free written quote, priced per opening.
- Licensed under Alabama's Home Builders Licensure Law
- General liability plus workers compensation on every crew that shows up
- Installation warranty held separately from the manufacturer's
- Tuscaloosa, Bibb, Hale, Pickens, Fayette, Walker and Greene counties
Tuscaloosa Window: Every Service
Full Window Replacement
How a whole-house order is released decides how the job actually runs. Order every unit at once and the house is done in one visit.
Residential Window Installation
There is one correct order for the layers around a window, and it is the whole job. Every piece overlaps the piece below it, from the pan at the bottom to the flashing at the head, so water always meets a downhill surface.
Commercial Window Installation
Commercial glass in Tuscaloosa splits along the same line the houses do, and the split is again about what the wall is made of rather than what the glass costs. Downtown and along the older Northport blocks, the storefronts sit in load-bearing masonry.
Energy-Efficient Window Installation
The efficiency of a window in Tuscaloosa is decided mostly by how it gets into the wall. Our stock is brick veneer built up around the original frames, and that single construction fact drives every honest recommendation on this page.
Vinyl Window Replacement
For most brick houses in this county, vinyl is the right answer, and we say so knowing full well that it is the cheapest option available. The wall is the reason, not your budget.
Wood Window Replacement
Clad-wood belongs on a short list of Tuscaloosa openings, and the list is defined by what the exterior wall will let us build behind the cladding. Get that wrong and you have bought a wood window with a drainage problem.
Aluminum Window Replacement
Aluminum has two honest lives in this city. It is the frame in a 1970s ranch that is on its way out, and it is the correct specification for a span no hollow frame should be asked to hold.
Bay and Bow Windows
This is the page where we most often talk people out of what they came for. On a brick-veneer wall, cutting in a new bay or bow is an expensive structural job dressed up as a window purchase.
Broken Window Glass Installation
A broken lite behind otherwise working hardware is an errand for a glazing shop, and we will give you a name. What this page takes on is glass for openings framed, rebuilt or altered, which in Tuscaloosa still often means a wall put back after 2011.
Casement Window Replacement
Casements are the one style where our usual advice reverses. In a brick-veneer opening a casement loses so much glass to a pocket insert that we would rather you did the job properly or not at all.
Custom Window Installation
Our stock is brick veneer built up around the original frames, with a steel lintel angle carrying the brick over the opening. Custom work in Tuscaloosa starts there, because the opening is a masonry fact before it is a measurement.
Double-Pane Window Replacement
Double pane is the standard, and nobody should charge you for the news. Every replacement window quoted in Tuscaloosa is two sealed lites.
Egress Windows
Egress work in Tuscaloosa County is rarely the basement job people expect. Most houses here sit on a slab or a crawlspace, so the openings that fail are in converted attics, additions and rooms that were called bedrooms without ever meeting the rule.
Fiberglass Window Replacement
Fiberglass has two clear homes in this county. The review districts, where bare vinyl is excluded from the approved materials list and fiberglass is on it, and the post-2011 rebuild walls, where a full-frame install is possible and a stiffer frame stops being wasted.
French Doors
A hinged pair is the least forgiving door you can put in a masonry opening. It needs a level sill, a head that does not move, and jambs that stay parallel, and a brick-veneer wall of a certain age does not always offer all three.
Impact Window Installation
Laminated glass is a genuinely good product that gets sold here for the wrong reason. We sell it for noise, ultraviolet and forced entry, and we are careful about what we claim beyond that.
Low-E Glass Window Installation
On a brick-veneer insert you have already paid for the window in glass area. The coating is the one specification left that costs you none of it, which makes it the best value on a Tuscaloosa order and the least understood line on the quote.
Multifamily & HOA Window Replacement
The most useful document on an association's window project is not a quote. It is a survey: every opening on the property typed, located and graded, so a board can see what has to be spent and in which year.
Office & Commercial Glazing
Street-level glass has its own page on this site, with the carts, the bollards and the walkway that come with it. This page starts one floor up, where none of those things apply and almost everything else changes.
Retrofit Windows
There is one honest test for whether a retrofit window suits your house, and it takes a screwdriver. Push the blade into the bottom corner of the existing sill.
Sliding Window Door Replacement
Sliders are everywhere in the 1970s ranch stock across Tuscaloosa County, and in the houses near campus that have been rented for a generation. They are also the style people replace most often without ever needing to.
Soundproof Window Installation
Two panes of the same thickness are the single most common mistake in a quiet window. They flex in step, they release the same sound in step, and most of what gets bought for noise has exactly that fault built into it.
Storefront Window Installation
Glass at street level is broken by objects, not by weather, and in this city the objects are seasonal. Furniture moves in August and out again in May, and a great deal of it goes past a shopfront on the way.
Triple-Pane Window Installation
Tuscaloosa County is zone 3A and mixed-humid, which means a long cooling season and a brief winter. A third pane is built for the opposite climate.
Tuscaloosa Window Pros handles window replacement in Tuscaloosa, Alabama, along with insulated glass repair, patio doors, entry doors and commercial storefront glazing. We fit vinyl, pultruded fiberglass, thermally broken aluminum and clad-wood units, and we set every one of them to a stated method rather than a stated brand.
That method is decided by the wall, not the window. A brick veneer over a wood-framed wall, which covers most houses built here between the 1950s and the 2000s, seals the opening from outside and leaves a pocket insert as the only sensible route. A clad wall with the unit flanged to the sheathing, common in the newer subdivisions, allows a full-frame install with the flashing lapped properly over the fin.
So the first thing on our proposal is the assembly at each opening, then the install method, then the glass package, then the price. We quote balance kits, roller sets and glass-only work on the same sheet as replacement, because on plenty of Tuscaloosa County houses the smaller job is the correct one and you should be able to see it.
What Tuscaloosa Customers Say
They looked at the outside of the wall before they quoted anything and explained why our brick house could only take inserts. Nobody else did that. The estimate showed the glass size we would end up with at each window, which is the part I did not know to ask about.
Called about replacing nine windows and ended up replacing two and getting new balances and weatherstrip on the rest. They talked me out of most of the job. The two that were genuinely gone went in cleanly and the sills were sealed properly on the inside.
Our patio door had to be lifted with a shoulder to move it. New rollers and a track cap and it slides with a finger now. They quoted a replacement door as well so I could compare, but told me straight the frame was fine.
Two fogged units in a twelve year old house. They measured at the sightline, checked the tempered mark, and came back with matching glass. Kept the original install and the flashing alone, which they explained was the whole point.
Why Tuscaloosa Chooses Tuscaloosa Window Pros
- ✓We read the outside of the wall before the inside of the window, because a brick-veneer opening and a flanged clad-wall opening are two different jobs at two different prices
- ✓Every proposal states whether the unit is a pocket insert or a full-frame replacement, and how much glass width you give up to get the cheaper one
- ✓We will not cut a brick veneer to sell you a bigger opening when the existing masonry opening can carry the window you actually need
- ✓On clad walls we re-lap self-adhered flashing over the nailing fin in sequence, rather than running a bead of sealant around the perimeter and calling it flashed
- ✓Anchorage is specified separately from the window, because a design pressure earned in a test buck is not what you get screwing into a 1968 jamb liner
- ✓Alabama licenses this work through the Home Builders Licensure Board once a job passes ten thousand dollars, and we hand you the license number before you sign
About Tuscaloosa Window Pros in Tuscaloosa, AL
Tuscaloosa Window Pros is a window, glass and door company working across Tuscaloosa County and the counties around it. We fit vinyl, pultruded fiberglass, thermally broken aluminum and clad-wood units, replace sealed glass, rebuild sliders and hang patio, french and entry doors, and we glaze commercial storefronts downtown and in Northport.
The way we work comes from what the housing here is actually made of. Two wall assemblies dominate this county and they need opposite methods, so every proposal we write names the assembly, the install method and the glass package at each opening before it names a price. That is also why our quotes vary from opening to opening on the same house, and why we would rather explain it than average it.
There are jobs we will turn down. If your sash are sound and the complaint is drafts, we would rather sell you weatherstripping. If the header over an opening has moved, we will not hang a hinged door in it and let you find out next summer. And if you want a rated impact installation on a brick-veneer opening we cannot anchor properly, we will decline and tell you why.
How It Works
- 1
Read the wall at every opening
We check the head and jamb detail from outside before anything else: a mortar joint with a brick mold casing means a masonry opening and an insert, while a flashing lap over a trim board means a clad wall that can take a full-frame unit. The finding goes on the proposal per opening.
- 2
Measure the opening, not the window
Every opening is measured at head, sill and both jambs and diagonally in both directions, and the reveal gaps are written on the job sheet. An opening that has racked out of square then shows up at the estimate rather than on install day.
- 3
Quote the repair alongside the replacement
Balances, jamb liners, tandem rollers, track caps, pile weatherstrip and sealed units are all priced on the same page as new windows. Where the smaller job is the right one, it is the one we recommend and the one we will take.
- 4
Install to the method on the sheet
Inserts are anchored on composite shims at every load point, foamed lightly with a minimal-expanding product and sealed at the interior perimeter. Full-frame units get a sloped pan with end dams and self-adhered flashing lapped head over jamb over sill.
Commercial storefront, entrance and office glass
Commercial work in Tuscaloosa splits the same way the houses do. Downtown and the older Northport blocks are load-bearing masonry with openings that never repeat, so every one is measured individually. The retail and office space built since the early 2010s is framed and clad, with storefront anchored to structure, and those can be ordered to a schedule. We handle both, along with the entrance repairs that keep a business open.
- ✓Aluminum storefront framing in center-set and front-set profiles, thermally broken where the space is conditioned
- ✓Tempered and laminated safety glazing specified by position, with the etched mark checked on every existing lite
- ✓Medium and wide stile entrance doors, pivots, closers, thresholds and panic hardware
- ✓Accessibility checks on clear width, threshold height and opening force whenever a threshold is touched
- ✓Insulated storefront units and curtain wall glass replacement in occupied buildings
- ✓Same-day board-up with tempered lead times quoted honestly rather than promised away
- ✓Office and campus-adjacent retail glazing scheduled around trading hours
- ✓Opening schedules handed over on paper: sizes, glass types, hardware models and finishes
Towns We Cover
Tuscaloosa Window Pros serves Tuscaloosa, AL and surrounding communities including:
Recent Projects Across Tuscaloosa County and the Black Warrior valley
Full gallery →
Frequently Asked Questions
Why does my brick house limit what windows I can have?
Because the brick veneer was built up around the original window frame, with a brick mold casing bedded into the mortar. There is no way to reach a nailing flange or re-lap a weather barrier without taking masonry apart, so the practical route is a pocket insert set from inside. That works well, but it costs you roughly two to three inches of glass in each direction, and we will tell you exactly how much at each opening.
My house was rebuilt after the April 2011 tornado. What is different about its windows?
Houses rebuilt in the years afterwards were generally built as new construction, which means the windows are flanged units fastened to the sheathing behind siding or a later veneer. Those installs are usually fine. What is reaching the end of its life now is the sealed glass, which typically starts fogging somewhere between twelve and fifteen years. On those houses the correct repair is normally the glass, not the window.
Do I need impact-rated windows in Tuscaloosa?
Nothing in Tuscaloosa County requires them. The coastal wind-borne debris provisions apply to the Gulf counties, not here. Laminated glass is still worth buying for noise, ultraviolet and forced-entry resistance, and those benefits do not depend on how the frame is anchored. A design-pressure rating does depend on anchorage, and in a pocket insert it cannot be reproduced, so we will not print one.
Is a fogged window a repair or a replacement?
Almost always a repair. Condensation between the panes is a failed edge seal, and the frame, hardware and installation are unaffected by it. We measure the unit at the sightline, match the thickness and the coating position, and set a new sealed unit on blocks at the quarter points. It costs a fraction of a replacement and takes an hour once the glass arrives.
Are you licensed to do this work in Alabama?
Alabama regulates residential work through the Home Builders Licensure Board under Title 34 Chapter 14A, and a license is required once the cost of the undertaking exceeds ten thousand dollars. We carry that license and will give you the number before you sign anything. We also carry general liability and workers compensation, and we will send certificates directly on request.
Which areas around Tuscaloosa do you cover?
Tuscaloosa County first, including Northport, Holt, Cottondale, Coaling, Brookwood, Coker, Vance and Lake View. We also work regularly into Bibb, Hale, Pickens, Fayette, Walker, Greene and western Jefferson counties. Jobs further out are scheduled as full days rather than single openings, which keeps the travel off your invoice.